Standing waves observed using near-field radar measurements.
I just began to experiment with a low power (5 dB m) continuous and pulsed radar. I am hoping to use the radar to measure the radar cross section (RCS) of different materials. This experiment is intended to compare the RCS with surface emissivity measurements obtained radiometrically. However, I observed wave interference in the measurements similar to the case of a slotted line that I am trying to eliminate. I tried using separate antennas spaced apart as well a single antenna using a circulator for separation and got the same interference pattern. Any suggestions or explanations would be appreciated.
Use a VNA in time domain mode to gate out the reflections.
Sign in or register to add a comment.
Add a Comment
About Our Site
Biological Effects and Applications
Computer Aided Design
Emerging Applications and Technology
Filters and Passives
MMIC and RFIC
Packaging and Materials
Sources and Receivers
Test and Measurement
Spectrum Analyzers and NLFM Pulse Compression measurements
YIG detection - DC Magnetic Field
Field phases in quasi TEM
Terms of Service
Useful Hints and Tips
Created with PlushForums
© 2022 Microwaves 101 Discussion Board